Setting The Hd/Rgb Input - Roland V-440HD Owner's Manual

Setting the HD/RGB Input

With the HD/RGB inputs, the image's dimensions and color may
vary with each individual format and/or device, so it may be
necessary to make separate settings for each input individually.
The default factory setting for the HD/RGB input format is
"AUTO," whereby the settings are determined automatically.
Settings
Make the HD/RGB video settings with "2. HD/RGB Input" in the
menu. With "2. HD/RGB Input," you can select from the HD/RGB
Channel A/B and 1–4, and set the following parameters.
* For more on the menus, refer to "Menu Operations" (p. 25).
* To quickly go to the input settings menu, hold the MENU button and
press any of the HD/RGB Buttons 1–4.
2. HD/RGB Input Settings Parameters
Format Auto Detect Function automatically distinguishes input
Input Format Input format select
Pre Scaling Mode Switches scaling adjustment function on and off
Manual Pre Scaling Adjusts scaling ratio when full scaling used
Scaling Type Scaling method
Manual X Scale Adjusts the horizontal expansion ratio
Manual Y Scale Adjusts the vertical expansion ratio
X Position Fine adjustment of the horizontal start position
Y Position Fine adjustment of the vertical start position
Brightness Brightness adjustment
Contrast Contrast adjustment
Saturation Saturation adjustment
Red Red adjustment
Green Green adjustment
Blue Blue adjustment
Frequency Fine adjustment of the Sampling Frequency
Phase Fine adjustment of the Sampling Phase
Sw Enable Selects Enable or Disable for the selected channel
button
Input Ch Reset Resets the above settings to the original factory
settings
Input and Output Settings
About HD Input
The V-440HD is compatible with the following HD signal formats.
• 1080 59.94i / 50i: (SMPTE 274M)
• 720 59.94p / 50p: (SMPTE 296M)
About RGB Input
The V-440HD is compatible with the following RGB signal formats.
• 640x480 60 / 75Hz
• 800x600 60 / 75Hz
• 1024x768 60 / 75Hz
• 1280x768 60 / 75Hz
• 1280x1024 60Hz
* Units: [horizontal (pixels) x vertical (lines) / frame rate (Hertz)].
* Certain signal conditions may produce differences in the aspect ratio
and position of the RGB input. If this occurs, make adjustments with
the "X position," "Y position," "Frequency," "Phase" or other
relevant settings from the menu.
Automatic setting for the RGB input
Hold down the HD/RGB IN button corresponding to
the RGB signal being input for at least 3 seconds; the V-440HD
automatically detects the signal being input and makes the
appropriate settings. When the signal detection is completed, all
of the HD/RGB buttons flash.
27