Warranty - Hilti DX 76 Operating Instructions Manual

11. Warranty

Hilti warrants that the product supplied is free of defects
in material and workmanship. This warranty is valid as
long as the product is operated and handled correctly,
cleaned and serviced properly and in accordance with
the Hilti operating instructions, all warranty claims are
made within 5 years from the date of sale (invoice date)
for the tool and 1 year from the date of sale (invoice date)
for the magazine and ancillary equipment (unless other
mandatory national regulations prescribe a longer min-
imum period) and the technical system is maintained,
i.e. only genuine Hilti consum ables, accessories and
spare parts, or those of equivalent quality, are used with
the product.
This warranty provides the free-of-charge repair or replace-
ment of defective parts only. Parts requiring repair or
replacement as a result of normal wear and tear are not
covered by this warranty.
Additional claims are excluded, unless mandatory
national regulations prohibit such exclusion. In par-
ticular, Hilti is not obligated for direct, indirect, inci-
dental or consequential damages, losses or expenses
in connection with, or by reason of, the use of, or inabil-
ity to use the product for any purpose. Implied war-
ranties of merchantability or fitness for a particular
purpose are specifically excluded.
Send the product and/or related parts immediately upon
discovery of a defect to the local Hilti marketing organi-
zation for repair or replacement.
This constitutes Hilti's entire obligation with regard to
warranty and supersedes all prior or contemporaneous
comments and verbal or written agreements concern-
ing warranties.
Confirmation of CIP testing
The Hilti DX 76 has been system and type tested. As a
result, the tool bears the rectangular PTB approval mark
showing approval number S 813. Hilti thus guarantees
compliance with the approved type. Unacceptable defects
or deficiencies, etc. determined during use of the tool
must be reported to the person responsible at the approval
authority (PTB) and to the Office of the Permanent Inter-
national Commission (C.I.P.).
Noise information
as per German legislation (3, GSGV dated January 18,
1991):
The noise (power) level L
able to the tool and, due to different workplaces depend-
ing on the application for which the tool is used, also the
noise (pressure) level L
pAImax
face of 1 meter as per § 1 (2) 1e), are given in addition
to the workplace related noise emission value in accor-
dance with the noise measurement standard. Operating
conditions and circumstances of use: most powerful car-
tridge power load in accordance with instructions for use
with suitable fastener or stud fired vertically downwards
into a concrete block and in accordance with the means
of measurement DIN 45635, part 34 " Measurement of
the noise emitted by machines – airborne noise, surface
sound transmission – methods – powder-actuated fas-
tening tools " .
Noise information: Noise information with typical appli-
cation* :
1b) Noise (power) level
workplace-relevant
emission value
1e) Noise (pressure) level
Variations in operating conditions may cause devi-
ations from these noise emission values.
* ENP nail with cartridge 6.8/18 M red and power level
2 on 20 mm steel with 370 N/mm
as per § 1 (2) 1b) applic-
WA,1S
, at the measurement sur-
L = 117 dB (A)
WA, 1S
L = 114 dB (A)
pAImax
–
= 104 dB (A)
L'
pA, 1s
2
en
31