Advertisement
D40-1132-05
1.11. ™7FR PLATE/¡FR GEAR
Disassembling
(a) These parts will be removed when
removed.
Disassembling
¡
(a) Mount
FR GEAR on the boss of
(b) Insert this boss into portion B between
4
and
MAIN PLATE, and insert pin C of CHASSIS Ass'y
into a hole in the FR PLATE. Under this condition, shift
the FR PLATE so that the boss D meets a hole in the
CHASSIS Ass'y.
(c) From the back side, check the assembling condition with
the CHASSIS Ass'y.
1.12. =P GEAR/9P.G PLATE
CAUTION:
These parts cannot be reused, and they should be scrapped
after removed.
Disassembling
(a) Insert a flat-head screwdriver under the Gear and raise it
to remove the Gear from
4
(b) Slide
MAIN PLATE up to the position shown in figure.
(c) Turn and remove
CHASSIS).
Reassembling
(a) Adjust the MAIN PLATE to the position in previous step
(b).
(b) Insert a hex. portion of
meet a hole in the Plate with a hole in the CHASSIS
Ass'y. (In such a case, insert the PG PLATE in the direc-
tion as shown, and turn it to adjust both holes.)
(c) Fit forcibly the p GEAR into a hole in PG PLATE.
(d) Moving the MAIN PLATE, make sure that the PG PLATE
moves smoothly.
10
DISASSEMBLY FOR REPAIR
&
OP PLATE Ass'y is
™
FR PLATE.
1
CHASSIS Ass'y
9
P.G PLATE.
9
PG PLATE downward (upward of
9
PG PLATE into a hole, and
Advertisement
