Advertisement
1.4. –REEL Ass'y/‚FL CAPSTAN Ass'y/∞§PINCH ROLLER Ass'y
CAUTION:
As :REEL CAP/∞§PINCH ROLLER Ass'y are damageable during disassembling, they cannot be reused.
Disassembling
(a) Open and remove the Washer at the lead edge of
...REEL Ass'y as shown in figure. (The washer is dam-
ageable, and it cannot be reused.)
(b) Raise and remove :REEL CAP/REEL Ass'y.
(c) For ‚FL CAPSTAN Ass'y, open and remove the Washer
in the same manner.
(d) Remove the FL CAPSTAN Ass'y from the bottom (In
such a case, HJP WASHERS may stay on the Chassis,
and take care not to allow them to enter the deck.) (See
Fig.(d) in next item)
(e) Insert a flat-head screwdriver into ∞§PINCH ROLLER
Ass'y as shown in figure, and raise the Ass'y until it
clicks. Thus, it will be unlocked.
(f) Then, remove the Pinch Roller Ass'y by hand.
Reassembling
(a) Insert the ...REEL Ass'y into the REEL SHAFT.
(b) Insert "REEL WING SPRING, then a :REEL CAP on
it, and push them until they pass through the REEL
SHAFT.
(c) Under this condition, insert BP WASHER CUT.
(d) Insert the ‚FL CAPSTAN Ass'y into the CHASSIS Ass'y
and lock with GP WASHER (At this time, don't forget to
insert HJP WASHERS.)
(e) The PINCH ROLLER Ass'y is designed so as to be fit by
a force, and therefore insert it into the SHAFT of
1CHASSIS Ass'y at portions F and R.
(f) The PINCH ROLLER Ass'y is designed so as to be fit by
a force, and therefore insert it into the SHAFT of
1CHASSIS Ass'y at portions F and R. Next, press to fit
the Springs attaching to @HEAD PANEL Ass'y at both F
and R in the same manner.
DISASSEMBLY FOR REPAIR
D40-1132-05
5
Advertisement
