Advertisement
Technical specifications Pro-Ject MaiA Pre
Variable line level output :
Headphone output :
Output voltage :
Output impedance :
Frequency response :
Noise floor :
THD :
Gain :
Line level inputs :
Line input sensitivity :
Line input impedance :
Phono input :
Phono input sensitivity :
Phono input impedance :
Phono input gain :
S/PDIF coaxial input :
S/PDIF optical input :
USB input :
USB data transfer :
Digital to Analogue converter :
Bluetooth music receiver codec :
Bluetooth range :
Outboard power supply :
Power consumption :
Replacement battery remote control :
Dimensions W x H x D (D with sockets) :
Weight :
Service
Should you encounter a problem which you are not able to alleviate or identify, please contact your dealer for
further advice. Only if the problem cannot be resolved there, the unit should be sent to the responsible
distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or changes to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.
Copyright, trademarks
Pro-Ject Audio Systems is a registered Trademark of
H. Lichtenegger.
This guide was produced by: Pro-Ject Audio Systems
Copyright
©
2014. All rights reserved.
© Pro-Ject Audio Systems · Pro-Ject MaiA, MaiA Pre · Revision 2014.10.8 (from S/N: E29069)
1 pair RCA
6,3mm jack (16 – 600ohms)
2V RMS
100 ohms
20Hz - 20kHz (max. deviation 0,3dB)
> -95dB (A-weighted)
< 0,01%
6 dB (measured via line level input)
2 pair RCA + 1 3.5mm jack
350mV
50kohms
1 pair RCA
suitable for MM, MI or high output MC cartridges
47 kohms
46 dB
up to 24bit and 192kHz
up to 24bit and 96kHz
USB Audio Class 2 (requires USB 2.0 or higher on computer)
Asynchronous
Cirrus Logic CS4344 24bit/192kHz Multi-bit Delta Sigma type
aptX, A2DP profile
10 meters in direct visibility between source and receiver
18V/1A DC, suitable for your country's mains supply
max. 250mA DC, <0.5W in standby
1 x CR2032 / 3V or 1 x CR2025 / 3V
206 x 36 x 150 (157) mm
1100 g without power supply
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.
7
Advertisement
