Siemens Family 1650 Operating And Installation Instructions page 43

Install the tap with the machine on water supply
pipe.(the tap is on the bottom pad)
1. First, close the water supply valve of your house.
4 4
2. Turn on all the taps of your house completely. C-
min. min.
3. Remove the tap that you want to change(the
4. Close all the opened taps.
5. Open the water supply valve a little, the water
6. After cleaning, close the water supply valve
7. Wrap enough seal tape at the end of the metal
8. Install the tap tightly on the supply pipe.
9. Turn on the installed tap.(refer to the picture
10.
The filters at the free end of the inlet hose and
at the back of machine should only be removed
for cleaning purposes.
To avoid water damage the tap must be turned
OFF after using the machine.
The plastic nuts on the hose connections must
only be tightened by hand.
The following is connecting procedure of the wa-
ter tap and inlet hose:(carry out by an authorized
technician)
ollect residual water in supply pipe with container.
tap is in open state).
will be out from the nozzle which the tap to be
installed. Clean the nozzle and the residue
inside the pipe(e.g. rust).
again.
tap which connect to the water supply pipe.
left)
Open the water supply valve, close the tap till
the water become transparent. After several
minutes, check that connection points are
water-tight . If not, reinstall the tap.
41