Siemens Family 1650 Operating And Installation Instructions page 34

Fault
Control lights do not
come on.
The programme does not start.
The buzzer sounds an alarm.
Programme does not start.
Water does not enter the
machine or detergent is
not wash away.
The buzzer sounds an alarm.
Detergent in chamber I is
not wash away.
Water cannot be seen in
drum.
Washing solution is not
completely drained.
The buzzer sounds an alarm.
Water is flowing out from
underneath the machine.
When sounds an alarm, the sound rhythm of buzzer is hurried than usual (e.g. After
the programme ended properly), and the working duration is ten minutes.
32
Cause
A fuse has triggered.
Power failure.
Plug is loose or not inserted.
Loading door not closed.
,, ,,
Start button does not
pressed.
Water tap not turned on.
Supply hose kinked or
trapped.
Strainer in supply hose
clogged.
A programme without Prewash
was selected.
This is not a fault.
The water lies below the visible part of the drum.
Loose debris is blocking
the pump.
Fluff-producing laundry was
washed at a high temperat-
ure. The water drainage
pipe or drain hose is
blocked.
The thread of the supply
hose is not tight.
Leak in the drain hose.
Action
Switch on/replace the fuse.
Call Customer Service if this fault
is repeated.
An interrupted programme will be
resumed when power retures. If you
wish to unload the laundry, proce-
ed as in Cleaning the drain pump ,
Page 28.
Check whether laundry is trapped
in door.
Close the loading door(a click sh-
ould be heard).
,, ,,
Press the Start button.
Turn on water tap.
Clean the strainer
(refer to Page 29)
Select 60 C Cottons/coloureds
,, ,,
with Prewash .
Clean the pump.
(refer to Page 28)
Clean the water drainage pipe
and/or drain hose.
Tighten the thread.
Replace the drain hose.
,, ,,