Technical Data; Overview; Assembly; Oiling The Chain - Black & Decker Saw Manual

E N G L I S H
The extension cable contains two wires, which are
colour coded for easy identification: brown is for
Live (L), blue is for Neutral (N). The connector is
marked ‚L' for Live and ‚N' for Neutral.
These markings are located inside the body near
the terminal screws (see below).
Lift out the cable protector.
Pass the cable through from the narrow end of
the cable protector.
Prepare the cable ends to the strip length
shown in the illustration.
Remove the cable clamp.
Loosen the terminal screws until you can enter
the stripped wires between the raised washer
and the terminal.
Connect the brown lead to the terminal
marked ‚L' and the blue lead to the terminal
marked ‚N'. Do not fix the wires directly under
the screw head.
Locate the cable and cable protector into the
body.
Fit the cable clamp over the outer sheath of
the cable. Tighten the screws until fully home.
Make sure that the cable clamp is firmly
holding the outer sheath of the cable and that
the two leads are correctly fixed.
Place the cover onto the connector body.
Securely tighten the fixing screw.
Check that the cable protector is secure and
that there are no gaps between the connector
body and the cover.
connector body
terminal screws
clamping washers
6 mm
30 mm
cable
clamp
a
cable
protector
12
fixing screw
b c
cover
Additional safety instructions for Australia and
New Zealand
This appliance is not intended for use by
young or infirm persons without supervision.
Children must be supervised to ensure they do
not play with the appliance.
If the supply cord is damaged, it must be replaced
by the manufacturer or an authorised
Black & Decker Service Centre in order to
avoid a hazard.

Technical data

Bar length
Supply voltage (V)
Rated input (W)
Max. cutting length (cm)
Chain speed (no load m/s) 8
Weight (kg)
Oil capacity (ml)
Safety class
OVERVIEW (fig. A)
1. On/off switch
2. Lock-off button
3. Oil cap
4. Oil level indicator
5. Front guard/chain brake
6. Chain cover
7. Control knob
8. Guide bar
9. Chain
10. Chain sheath

ASSEMBLY

Before assembly, make sure that the tool
is switched off and unplugged.
Oiling the chain (fig. A)
You must do this whenever you use a new
chain for the first time. Take the new chain out
of its plastic bag and soak it in chain oil for at
least an hour before using it. Use Black & Decker
chain oil (cat. no. A6027).
30 cm 35 cm 40 cm
230 230 230
1400/1600 1400/1600 1400/1600
30 35 40
8 8
3.7 3.8 3.9
180 180 180
II II II