Black & Decker CS2040 Original Instructions Manual

Black & Decker CS2040 Original Instructions Manual

Hide thumbs Also See for CS2040:




Table of Contents

Summary of Contents for Black & Decker CS2040

  • Page 1 CS2040 CS2245
  • Page 6: Intended Use

    ENGLISH (Original instructions) Intended use 3. Personal safety a. Stay alert, watch what you are doing and use common Your BLACK+DECKER chainsaw has been designed for sense when operating a power tool. Do not use a pruning and felling trees and cutting logs. This tool is intended power tool while you are tired or under the influence for consumer use only.
  • Page 7: Causes And Operator Prevention Of Kickback

    (Original instructions) ENGLISH e. Maintain power tools. Check for misalignment or When cutting a limb that is under tension be alert binding of moving parts, breakage of parts and any for spring back. When the tension in the wood fibres is other condition that may affect the power tools released the spring loaded limb may strike the operator operation.
  • Page 8: Additional Safety Instructions

    ENGLISH (Original instructions) Safety of others Only use replacement guide bars and chains specified by the manufacturer. Incorrect replacement guide bars This appliance is not intended for use by persons (includ- and chains may cause chain breakage and/or kickback. ing children) with reduced physical, sensory or mental Follow the manufacturer's sharpening and mainte- capabilities, or lack of experience and knowledge, unless nance instructions for the saw chain.
  • Page 9 (Original instructions) ENGLISH Labels on tool Voltage drops Under certain power supply conditions this product may- The following pictograms are shown on the tool: cause short-time voltage drops during start-up. Other equipment may be affected. For example, electri- Warning! To reduce the risk of injury, the user clights may temporarily reduce in brightness.
  • Page 10 ENGLISH (Original instructions) Oiling the chain Increasing the chain tension (fig.B) You must do this whenever you use a new chain (5) for the Loosen the chain adjust locking knob (7) counterclockwise first time. Take the new chain (5) and soak it in chain oil for at one half turn.
  • Page 11 (Original instructions) ENGLISH When the motor starts, remove your thumb from the lock The intended direction of fall. button (2) and grip the handle firmly. The natural lean of the tree. Do not force the tool, allow the tool to do the work. It will do Any unusual heavy limb structure or decay.
  • Page 12: Maintenance

    ENGLISH (Original instructions) When supported along its whole length: Problem Possible cause Possible solution Make a downward cut, but avoid cutting the earth as this will blunt your saw chain quickly. Chain tension is too Chain does not stop Check chain tension slack within 2 seconds When supported at both ends:...
  • Page 13: Technical Data

    Technical data Saw chain tension Regularly check the saw chain tension. CS2040 CS2245 What to do if your chainsaw needs repair. (Type 1) (Type 1) Your chainsaw is manufactured in accordance with the rel-...
  • Page 14 TÜV Rheinland LGA Products GmbH; Tillystraße 2 D - 90431 N¨¹rnberg, Germany; Notified Body ID No.:0197...
  • Page 15 Australia Black & Decker (Australia) Pty. Ltd. Tel. 03-8720 5100 20 Fletcher Road, Mooroolbark, 03-9727 5940 Victoria, 3138 New Zealand Black & Decker Tel. +64 9 259 1133 5 Te Apunga Place +64 9 259 1122 Mt Wellington Aukland 1060 United Kingdom &...

This manual is also suitable for:


Table of Contents