Table of Contents
Advertisement
BEFORE OPERATION
Matching Address between Indoor Unit and Remote Control
When two units are used in the same room, you can match the address of
the remote control to that of the unit.
Indoor Unit
Turn off the unit and pull out the power plug. Remove the insert grille and
terminal block cover.
Assign the address selector of one indoor unit as B.
Remote control
Refer the page 9.
NOTE
• This function must only be performed by qualified service personnel.
Signal Receiving
Use the remote control where its signals can reach the receiver of the air
conditioner. (A distance of 5m is allowed)
• You can hear a beep from the unit which indicates that the signal is received.
5m maximum
CAUTION
• The air conditioner will not operate if curtained, doors or other
materials block the signals from the remote control to the unit.
• If the infrared signal receiver on the unit is exposed to direct sunlight, the air
conditioner may not work properly. Draw the curtains to avoid direct sunlight.
• A mounting bracket for the remote control is supplied with the unit.
Install the mounting bracket on the wall where the remote signal can
be easily received from the remote.
7
Advertisement
Table of Contents
