Attaching The Eyepiece Cap; Viewfinder Accessories; Attaching A Remote Cord - Konica Minolta MAXXUM 5D Instruction Manual

ATTACHING THE EYEPIECE CAP

The supplied eyepiece cap prevents light from entering through the viewfinder and
affecting the exposure meter or fogging the image when using the self-timer or during
long exposures.
OPTIONAL VIEWFINDER ACCESSORIES
The Angle Finder V
makes using the camera at low angles easier. The Magnifier enlarges the center of the
viewfinder image for critical focusing especially for macro photography. These
accessories are mounted on the viewfinder frame as described above. For more
information on these and other accessories, contact your Konica Minolta dealer.

ATTACHING A REMOTE CORD

Carefully slide the eyepiece cup from around the
viewfinder frame by pushing on each side of the
cup.
Slide the eyepiece cap over the viewfinder. The cap
should be attached to the camera strap to prevent
loss. Replace the eyepiece cup after the exposure.
and Magnifier V
N N
The optional remote cords (RC-1000S or RC-1000L) can be used
to reduce vibrations from touching the camera during long
exposures. Open the remote-control terminal cover from the right.
The cover is attached to the body to prevent loss; take care not the
sever the connector. Insert the plug of the remote cord into the
terminal (1).
The cord can be attached to the camera strap. Open the
remote-cord clip on the strap and push the cord into the
grove. Close the clip until it clicks into place (2).
can be used with this camera. The Angle Finder
111