Disassembly Instructions - Mitsubishi Electric MUZ-GA50VA Service Manual

11

DISASSEMBLY INSTRUCTIONS

<"Terminal with locking mechanism" Detaching points>
The terminal which has the locking mechanism can be detached as shown below.
There are two types ( Refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not.
Sleeve
Locking lever
MUZ-GA50VA -
E1
OUTDOOR UNIT
OPERATING PROCEDURE
1. Removing the cabinet
(1) Remove the screws of the service panel.
(2) Remove the screws of the top panel.
(3) Remove the screw of the valve cover.
(4) Remove the service panel.
(5) Remove the top panel.
(6) Remove the valve cover.
(7) Remove the screws of the cabinet.
(8) Remove the cabinet.
(9) Remove the screws of the back panel.
(10) Remove the back panel.
Photo 3
Screws
of the
back
panel
Set screws of the back panel
1Slide the sleeve.
2Pull the terminal while
pushing the locking
lever.
MUZ-GA60VA -
E1
Screw of the motor support
(2) The terminal with this connector has the
locking mechanism.
MUZ-GA71VA -
E1
Photo 1
Screws
of the
cabinet
Photo 2
Screws
of the
cabinet
44
1Hold the sleeve, and
pull out the terminal
slowly.
Connector
NOTE :
These photos are MUZ-GA71VA.
Other models are almost the same as
MUZ-GA71VA.
PHOTOS
Screw of the top panel
Screws of the cabinet
Screw of the service panel
Screws
of the
top
panel
Screw
of the
valve
cover