Table of Contents
Advertisement
3.4
GAS PRESSURE
Outlet pressure can be checked to ensure it is measuring 3.5" W.C. (NG)
or 10.0" W.C. (LP).
3.4.1
Outlet pressure can be checked by removing cap (A) using a
3/16 Allen key and replacing it with a 1/8 NPT barb fitting.
3.4.2
Place pressure gauge tube over the fitting.
3.4.3
Once completed, be sure to replace the cap (A).
3.5
ELECTRICAL CONNECTION
DO NOT USE THIS APPLIANCE IF ANY PART HAS BEEN UNDER WATER. CALL A QUALIFIED SER-
VICE TECHNICIAN IMMEDIATELY TO HAVE THE APPLIANCE INSPECTED FOR DAMAGE TO THE
RISK OF ELECTRICAL SHOCK OR EXPLOSION. DO NOT WIRE 110V TO THE VALVE OR TO THE
APPLIANCE WALL SWITCH. INCORRECT WIRING WILL DAMAGE CONTROLS.
ALL WIRING SHOULD BE DONE BY A QUALIFIED ELECTRICIAN AND SHALL BE IN COMPLIANCE
WITH LOCAL CODES. IN THE ABSENCE OF LOCAL CODES, USE THE CURRENT CSA C22.1
CANADIAN ELECTRIC CODE IN CANADA OR THE CURRENT NATIONAL ELECTRIC CODE
It is not necessary to hard wire this appliance, however if accessories that do require power are being consid-
ered it is recommended to make your electrical connection during initial installation.
As illustrated, route a grounded 2-wire, 60HZ power cable to the junction box. At this point it must be strain
relieved and insulated.
1/8" GAP
ELECTRODE
HIGH
VOLTAGE
IGNITION
CABLE
WARNING
!
ELECTRICAL CIRCUIT.
ANSI/NFPA NO. 70 IN THE UNITED STATES.
NPT BARB
FITTING
PRESSURE
GAUGE
SENSOR
CERAMIC
BODY
11
1/8
A
3.5
NATURAL
GAS
10
PROPANE
GAS
10.1
W415-0847 / 09.15.09
Advertisement
Table of Contents
