Using The I7300 - Phonic i7300 User Manual

USING THE i7300

Changing the Input Level
the input level jog wheel should be used to change the
level of input that is being fed into the input ports on the
rear of the i700. turning the jog wheel will allow you
to chage the input level between -∞ and 6dB, as will be
displayed on the bottom line of the lcD screen. if, when
changing the input level, the jog wheel is not used for 2
seconds the lcD will revert back to the previous screen.
the input level control is also independent of preset
programs (meaning the input level is not changed when
recalling a preset).
Alternating Between Input Modes
to change he input type, simply press the input level jog
wheel; this will allow you to alternate between stereo
normal, stereo reverse, mono right and mono left. When
stereo normal or stereo reverse are selected the stereo
indicator to the left of the lcD display will illuminate (this
indicator will. of course, not illuminate when in either
mono mode). the input mode of the i700, like the input
level, is in no way changed when recalling a preset.
Selecting a Preset
To select a preset, first press the Preset / User key on the
front of the i700; this will enter you into a preset select
mode, allowing you to use the adjust control to select a
preset. Pressing the type key will allow you to switch to
different effect types (hall, Room, Plate and special).
each of which has 25 presets that can be browsed by
using the adjust control. each preset is individually
named to describe the effect, and is applied automatically
when scrolled to. Pushing the adjust control will select
the effect and exit the Preset selection mode of the
ReverbMaster.
Selecting User Presets
i700
user presets are chosen basically the same way as factory
ones. First press the Preset / user ke twice, after which
the user leD to the left of the lcD display will illuminate.
From here on, using the type key and the adjust control
will allow you to peruse the user presets in the exact
same way as selecting factory presets. When you have
found the preset most suitable for what you need, simply
press the Adjust control down to finalize.
Changing the Mix Level
use the Mix level jog wheel to change the ratio of
processed to unprocessed audio (or the saturation of
processed audio over unprocessed). When ou turn
this jog wheel the lce will show "Wet dry mix" and a
percentage between 0 and 100 on the bottom line (at 0,
or dry, the audio remains completely unprocessed). if the
jog wheel remains unused for  seconds the screen will
revert back to whatever was there before using the mix
level jog wheel.
Changing The EFX Level
To edit the Efx level, first push the Mix Level jog wheel
down twice, then turn to edit between 0 and 100 percent;
effectively changing the total effect output level. if the jog
wheel remains unused of  seconds the screen will revert
back to the previous screen.
5