Front Panel - Mitsubishi Electric MJ-E16VX-S1 Instruction Manual

Maintenance (Continued)
Photocatalytic filter
1
Remove the front panel and pre-
filter.
1 Remove holding
the bottom.
Performance is unaffected even
if the metal fins inside the main
unit are slightly bent.
2
Remove the photocatalytic filter.
3
Soak the photocatalytic filter in
water.
Do not use detergent or hot water.
Also, do not brush or rub while
soaking as this may damage the filter.
¡Stains may remain on the filter, but should not
affect performance.
¡The filter can be soaked for a total of eight
times. After that, replace with a new filter.
24
Once every three months

Front panel

Pre-filter
2 Remove
holding the
tabs.
Photocatalytic
filter
Pre-filter
Soak in cool to
lukewarm water for
30 minutes.
Soaking the filter in water, and leaving it to dry in the sun
renews the performance and prolongs service life. Perform
this every three months.
4
Dry the photocatalytic filter.
Do not hang with pegs as this may
damage the filter.
Do not use the filter while wet.
5
Fit the photocatalytic filter.
With the strips facing up, set the
photocatalytic filter inside the tabs
on the pre-filter.
Tabs (6)
6
Attach the pre-filter and front
panel.
1 Attach holding the
tabs.
Dry well in the sun (The
performance of the filter
renews with soaking, and
the photocatalytic effect
of the sunlight removes
remaining odorants).
2 Hook the top edge
to the top part of
the unit and push
the bottom in.