Table of Contents
Advertisement
Available languages
Available languages
2
INTRODUCTION
2.3
GUIDELINES FOR THE DISPOSAL
OF SCRAP PRODUCTS
2.3.1
DURING SERVICE LIFE
Used oil, oil filters and engine coolant are
hazardous materials and should be handled in a safe
and environmentally responsible way.
In the event of a fluid leak, contain the spill to
prevent it entering the ground or drainage system.
Local legislation will dictate how such spills are to
treated.
Following the maintenance procedures laid out in
this manual will ensure that the impact the machine
has on the local environment is controlled.
When it has been identified that a turf care product
has no further functional value and requires disposal,
the following actions should be taken.
2.3.2
END OF SERVICE LIFE
These guidelines should be used in conjunction with
applicable Health, Safety and Environmental
legislation and use of approved local facilities for
waste disposal and recycling.
•
Position the machine in a suitable location for
any necessary lifting equipment to be used.
•
Use appropriate tools and Personal Protective
Equipment (PPE) and take guidance from the
technical manuals applicable to the machine.
•
Remove and store appropriately:
1.
Batteries
2.
Fuel residue
3.
Engine coolant
4.
Oils
•
Disassemble the structure of the machine
referring to the technical manuals where
appropriate. Special attention should be made
for dealing with 'stored energy' within
pressurised elements of the machine or
tensioned springs.
•
Any items that still have a useful service life
as second hand components or can be re-
serviced should be separated and returned to
the relevant centre.
•
Other worn out items should be separated into
material groups for recycling and disposal
GB-6
SAFETY, OPERATORS & MAINTENANCE MANUAL
consistent with available facilities. More
common separation types are as follows:
•
•
•
•
•
•
Items that cannot be separated economically
into different material groups should be added
to the 'General waste' area.
•
Do not incinerate waste.
Finally update machinery records to indicate that the
machine has been taken out of service and
scrapped. Provide this serial number to Jacobsen
Warranty department to close off relevant records.
Steel
Non ferrous metals
•
Aluminium
•
Brass
•
Copper
Plastics
•
Identifiable
•
Recyclable
•
Non recyclable
•
Not identified
Rubber
Electrical & Electronic Components
Advertisement
Chapters
Table of Contents
