3. Using Measure Modes
3.1 Measuring volts, millivolts and frequency
The calibrator can measure volts or frequency on these jacks. To make the desired
measurements, follow these steps:
1. Select the [CONFIG] option from the main menu.
2. Select the desired parameter for measurement.
3. Connect leads as shown in Figure 5.
VOLTS IN
-0.001 V
MENU
LIGHT
Figure 5. Measuring Volts and Frequency with Input/Output Terminals
3.2 Measuring mA
To measure mA follow these steps:
1. Select the [CONFIG] option from the main menu.
2. Choose [mA] from the primary parameters.
3. Make sure the input/output control is set to IN.
4. Connect leads as shown in Figure 6.
mA IN
0.000 mA
MENU
LIGHT
Figure 6. Measuring mA with Input/Output Terminals
10
+
-25.00%
+
–
–
MEASURE / SOURCE
3W
+
mA+
V
Ω
Hz
4W
–
mA–
MEASURE / SOURCE
3W
+
mA+
V
Ω
Hz
4W
–
mA–