Related Manuals for Martel T150
Summary of Contents for Martel T150
- Page 1 Model T150 Hand-held Frequency Calibrator OPERATING INSTRUCTIONS GlobalTestSupply www. .com Find Quality Products Online at: sales@GlobalTestSupply.com...
-
Page 2: General Description
General Description The T150 Frequency calibrator is designed to be a high accuracy, simple to use frequency standard for calibrating process control instrumentation. The T150 can generate or read frequencies ranging from 1 count per minute to 100 KHz allowing it to be used for a wide range of flow measuring instrumentation. -
Page 3: Operating Procedure
NOTE: The carrier will not honor any claims unless all shipping material is saved for their examination. After examining and removing contents, save packing material and carton in the event reshipment is necessary. Set-up Before beginning, become familiar with the keypad layout and the configuration of the input/output jacks. -
Page 4: Operating Modes
Operating Modes 1. When operating in the output mode the T150 has the capability to drive loads up to 1 kOhm with TTL levels. The standard output amplitude is a 5 volt ± 10% p-p square wave. Figure 1 2. When operating in the read (input) mode the T150 can monitor frequencies with amplitudes ranging from 1 to 100 volts. -
Page 5: Specifications
Specifications Input/Output Ranges 0 to 1000 CPM 0 to 1000 Hz 0 to 100.0 kHz Accuracy ±0.01% ± 1 count Max Load Driving 5 mA (1 kOhm load min) Input Signal Amplitude 1 to 100 Volts Output Waveform 5 V ± 10%, Square Wave Operating Temperature 0 to 50°C Storage Temperature... -
Page 6: Maintenance
12 months. Beyond this, it should be returned for re-calibration annually. If after the stated warranty period, the device falls out of calibration, or needs repair, it can be returned to Martel Electronics for re-calibration. Please Warranty Martel Electronics Corporation warrants all products against material defects and workmanship for a period of twelve (12) months after the date of shipment.