Setting The Cooling/Heating Selection Eligibility - Daikin BRC2E52C7 Operation Manual

Basic Operation Method
4
5

Setting the Cooling/Heating Selection Eligibility

Setting Changes
1
28
28
Operation manual
19
• Press the ON/OFF button.
The Operation lamp will be lit and the Heat
Reclaim Ventilation unit will start operating.
• When the ON/OFF button is pressed again the
Heat Reclaim Ventilation will stop operating and
the Operation lamp will turn OFF.
See "Cool/Heat Selection Eligibility" on page 21
cooling/heating selection eglibility.
• Press the Operation Mode Selector button on the
remote controller for at least 4 seconds. (During
backlight lit)
°C
The remote controller will not display "
(Changeover under control) if a cooling/heating
selection eligibility is granted to the remote
controller.
• The icon "
°C
controller of indoor units connected to the same outdoor unit or
BS (Branch Selection) box will start blinking.
• Set a cooling/heating selection eligibility as explained below.
Note
• Ventilation mode changes are possible regardless of the cooling/
heating selection eligibility.
• If a cooling/heating selection eligibility is set in the "cooling/
heating selection remote controller" ( ), the other remote
controllers will display "
case, the operation mode cannot be changed to respectively
cooling or heating when heating or cooling is set on the "cooling
or heating selection remote controller".
Refer to the Operation Manual provided to the outdoor unit for
the details on the "cooling/heating selection remote controller".
" (Changeover under control) on each remote
" (Changeover under control). In this
(VRV only)
for an explanation of the
"
BRC2E52C7 / BRC3E52C7
4P368042-1 - 2014.02