Pride Revo Owner's Manual page 25

V .
What type and size of battery should I use?
We recommend deep-cycle batteries that are sealed and maintenance free. Both AGM and Gel-Cell are deep-
cycle batteries that are similar in performance. Do not use wet-cell batteries, which have removable caps.
WARNING! Corrosive chemicals are contained in batteries. Use only AGM or Gel-Cell
batteries to reduce the risk of leakage or explosive conditions.
NOTE: Sealed batteries are not serviceable. Do not remove the caps.
Use these specifications to reorder batteries from your authorised Pride Provider:
Type:
Size:
Voltage:
Amperage:
To change a battery in your scooter:
WARNING! Battery posts, terminals, and related accessories contain lead and lead
compounds. Wash hands after handling.
1. Remove the seat.
2. Remove the battery packs from the scooter. Always
remove the left side battery pack first. See VIII.
“Disassembly and Assembly.”
3. Remove the 7 screws from the underside of the pack.
4. Arrange the pack so the handle is facing up and slowly
remove the cover and situate it as shown in figure 9.
5. Disconnect the battery cables from the battery termi-
nals by removing the nut and bolt from each terminal.
6. Remove the old battery.
7. Place a new battery into the battery pack.
8. Connect the red battery cable to the positive (+)
battery terminal.
9. Connect the black battery cable to the negative (-)
battery terminal.
10. Replace the battery pack cover.
11. Reinstall the 7 screws that hold the pack together
and tighten.
12. Reinstall the battery packs onto the scooter and close
the battery locks. Always reinstall the right side bat-
tery pack first.
13. Reinstall the seat.
Revo/Rev A/December 2003
B A T T E R I E S A N D C H A R G I N G
BATTERY SPECIFICATIONS
Deep-cycle (AGM or Gel-Cell)
U-1
12 volts each
32 AH (May vary)
BATTERY PACK COVER
Figure 9. Battery Replacement
www.pridemobility.com
BATTERY TERMINAL
BATTERY CABLE
BATTERY TERMINAL
BATTERY CABLE
25