Batteries And Charging - Pride Revo Owner's Manual

V .
Your scooter is equipped with two sealed, maintenance free batteries.
n Charge the batteries prior to using your scooter for the first time.
n Keep the batteries fully charged to keep your scooter running smoothly.
READING YOUR BATTERY VOLTAGE
The battery condition metre on the tiller console uses a
colour code to indicate the approximate strength of your
batteries. Green indicates fully charged batteries, yel-
low a draining charge, and red indicates that an imme-
diate recharge is necessary. See figure 7.
To check the battery strength during charging, you must
first unplug the charger power lead and power up your
scooter by inserting the key into the key switch.
NOTE: To ensure the highest accu-
racy, the battery condition metre
should be checked while operating
your scooter at full speed on a level
surface.
OFF-BOARD BATTERY CHARGER VOLTAGE SWITCH
The off-board charger supplied with your scooter is equipped with a 115/230 voltage switch. The voltage switch
is preset for your specific voltage and is intended to be used with a standard electrical outlet. Ensure this is the case
before attempting to insert the charger plug into the electrical outlet. If the setting is incorrect, the charger will not
function properly. Slide the switch to the prescribed position. See figure 7A.
NOTE: Follow instructions supplied with off-board charger.
22
B A T T E R I E S A N D C H A R G I N G
VOLTAGE SWITCH
Figure 7A. Voltage Switch
www.pridemobility.com
Figure 7. Battery Condition Metre
230
Revo/Rev A/December 2003