Pride Revo Owner's Manual page 23

Table of Contents

Advertisement

V .
B A T T E R I E S A N D C H A R G I N G
CHARGING THE BATTERIES ON THE SCOOTER
WARNING! Never use an extension lead to plug
in your battery charger. Plug the charger directly
into a properly wired standard wall outlet.
WARNING! Removal of the grounding prong can
create an electrical hazard.
properly install an approved 3-prong adapter to
an electrical outlet having 2-pronged plug
access. Failure to heed could result in personal
injury and or property damage.
Follow these easy steps to charge your batteries safely:
1. Position your scooter close to a standard wall outlet.
2. Remove the key from the key switch.
3. Make certain that the manual freewheel lever is in the drive
(pushed back) position.
4. Remove the charger power lead receptacle cover from the
charger power lead receptacle and plug the 3-pin charger power
lead into the receptacle. See figure 8.
5. Make sure the battery charger switch is in the “off” position.
See figure 8B.
6. Extend the charger power lead and plug it into the wall outlet.
7. Turn the charger on. See figure 8B. It is recommended that you
charge your batteries for 8 to 14 hours.
8. When the batteries are fully charged, turn the charger off and
unplug the charger power lead from the wall outlet and then from
the charger power lead receptacle.
9. Replace the charger power lead receptacle cover.
NOTE: There is a charger inhibit function on your
scooter. The scooter will not run and the bat-
tery condition metre will not operate if the
charger power lead is not disconnected from the
battery pack.
CHARGING THE BATTERIES OFF OF THE SCOOTER
Removing the battery packs and charging them off the scooter is
convenient should you want to leave the scooter in your vehicle.
To charge the batteries off of the scooter:
1. Remove the battery packs from the scooter and place them on a flat, dry surface in exactly the same positions
as they are on the scooter. See VIII. “Disassembly and Assembly” for information on how to remove and
position the battery packs.
2. Follow steps 4-9 from above.
3. Reinstall the batteries onto the scooter
Revo/Rev A/December 2003
If necessar y,
www.pridemobility.com
Figure 8. Charger Power Lead
Receptacle
PLUGS INTO THE CHARGER
POWER LEAD RECEPTACLE
ON/OFF SWITCH
Figure 8A. Off-Board Charger
OFF
ON
230
Figure 8B. Charger On/Off Switch
PLUGS INTO
WALL OUTLET
I
O
23

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents