Operation Instructions - Worx HandyCut WX424 Safety And Operating Manual

A
B
10
WA5030
Wood cutting blade
Max RPM: 7000
76mm
WA5031
Wood / Metal
All purposes blade
Max RPM: 15000
76mm
1.2x10mm
WA5033
Ceramic tile
Max RPM: 20000
76mm
C
Mini multi-function saw
24
44
TEETH HSS
80m/s
50
EN 13236
xxxxxxxx

oPeraTion inSTrucTionS

NOTE: Before using the tool, read the
instruction book carefully.
1. INSTALL /CHANGE THE BLADE (See Fig. A)
WARNING: Be sure to wear protective work
gloves while handling a saw blade. The
blade can injure unprotected hands.
WARNING: This tool will be extremely
hot after use. Be sure to let saw, blade
and blade spindle clamping screw cool before
changing blades.
a. Unplug the saw.
WARNING: To prevent personal injury,
Always disconnect the plug from power
source before assembling parts, making
adjustments or changing blades.
b. Loosen the blade spindle clamping screw using the
two hex keys included. Place one key into the blade
spindle clamping screw and the other key into the
back of the spindle assembly. (See Fig. A)
c. Turn the key that is in the clamping screw clockwise
while holding the other key stationary.
d. Remove the screw and the blade clamping washer.
(See Fig. B, C)
e. Set the depth of cut scale to the maximum depth of
22 mm. Release the blade release lever and rasie the
base with the finger lift bracket to expose the blade
below the base.
f. Grasp the blade with your gloved hand and remove
the blade, or install the blade, through the blade slot
in the base.
g. Place the new saw blade through the blade slot in
the base and onto the spindle shaft.
NOTE: The teeth of the blade should point
upward at the front of the saw as shown in
(See Fig. B).
NOTE: The warning copy and the Blade Rotation
Arrow shown on the blade should face outward
towards the operator so it can be viewed
(See Fig. C).
h. Replace the blade clamping washer .
i. Replace the spindle screw and hand tighten it in a
counterclockwise direction.
j. Use the two hex keys to tighten the spindle
clamping screw thoroughly.
k. Place the two hex keys back in the case.
NOTE: Never use a blade that is too thick to
WX424 WX424.1