Performax 90235 Operating Manual page 4

General safety rules (continued)
13. NEVER LEAVE A RUNNING TOOL UNATTENDED. Turn the power switch to OFF. Do
not leave the tool until it has come to a complete stop.
14. NEVER STAND ON A TOOL. Serious injury could result if the tool tips or is accidentally hit.
DO NOT store anything above or near the tool.
15. DO NOT OVERREACH. Keep proper footing and balance at all times. Wear oil-resistant
rubber-soled footwear. Keep the floor clear of oil, scrap, and other debris.
16. MAINTAIN TOOLS PROPERLY. ALWAYS keep tools clean and in good working order.
Follow instructions for lubricating and changing accessories.
17. CHECK FOR DAMAGED PARTS. Check for alignment of moving parts, jamming, breakage,
improper mounting, or any other conditions that may affect the tool's operation. Any part that is
damaged should be properly repaired or replaced before use.
18. MAKE THE WORKSHOP CHILDPROOF. Use padlocks and master switches and ALWAYS
remove starter keys.
19. DO NOT operate the tool if you are under the influence of drugs, alcohol, or medication that
could affect your ability to use the tool properly.
20. USE SAFETY GOGGLES AT ALL TIMES—that comply with
ANSI Z87.1. Normal safety glasses only have impact resistant lenses
and are not designed for safety. Wear a face or dust mask when
working in a dusty environment. Use ear protection, such as plugs or
muffs, during extended periods of operation.
Laser safety
1. Do not stare directly at the laser beam. Eye damage may
occur if you deliberately stare into the beam. Wear laser
enhancing glasses (not provided) when using the laser.
2. The laser light beam used in this system is Class III with ≤5
mW and 640–660 nm wavelengths. AVOID DIRECT EYE
EXPOSURE.
3. The laser must be used and maintained in accordance with
the manufacturer's instructions:
• Never aim the beam at any person or an object other
than the workpiece.
• Do not project the laser beam into the eyes of others.
• Always ensure the laser beam is aimed at a workpiece
without reflective surfaces as the laser beam could be
projected into your eyes or the eyes of others.
4