Operation - Performax 90235 Operating Manual

Operation

ON/OFF trigger switch
To start the cut-off saw, squeeze the trigger switch (1). To stop the cut-off saw, release the trigger
switch.
(Fig. 4)
Reset switch
If the cut-off saw does not start when the trigger switch is depressed, press the reset switch (2).
Then, squeeze the trigger switch to start.
Swiveling vise-clamp assembly with quick-release latch
Always secure the workpiece between the angle plate and the vise pressure plate when cutting.
1. Place the workpiece between the angle plate (1) and the vise pressure plate (2).
2. Push the vise screw (3) toward the angle plate and turn the vise wheel (4) clockwise to secure.
To release, turn the wheel counterclockwise two turns, raise the quick-release latch (5) and pull
the vise screw toward you.
(Fig. 6 and 7)
Angle plate
The angle plate can be moved forward, backward, or rotated for angle cutting.
1. To set a cutting angle, loosen the two bolts (1) and rotate the angle plate (3) up to 45° right or
45° left. Align the index (2) with the red line on the saw table. Retighten the bolts.
2. Always center the workpiece over the table slot web to maximize cutting depths. Move the vise
pressure plate (4) toward the angle plate (3). Use the wheel to secure the workpiece.
3. To move the angle plate (3), remove the two bolts (1) and washers. Move the angle plate to the
desired position and align the angle plate with the threaded holes on the saw base. Insert the two
bolts and washers and tighten to secure the angle plate to the table.
(Fig. 4)
10
(Fig. 5)