Chelsio Communications Chelsio T5 Installation And User Manual page 223

Chapter XVI. Bypass Driver
E.g.
[root@host]# bypass eth1 set --current_state normal
Here is a list of Bypass commands:
Command
bypass ethX get
bypass ethX set
bypass ethX get
bypass set
ethX
bypass get
ethX
bypass set
ethX
bypass get watchdog_timeout
ethX
bypass set watchdog_timeout
ethX
4.2.2. Operating the Switch (Examples)
The switch has three modes of operation; bypass, disconnect, and normal. These three modes
can be selected using the bypass CLI. The mode can be selected for the current operating state
or for the default state that is applied when powering up or after failure detection.
4.2.3. Bypass State
To obtain the current state of the switch:
[root@host]# bypass ethX get --current_state
To set the state of the switch:
[root@host]# bypass ethX set --current_state [bypass|disconnect|normal]
Chelsio T5/T4 Unified Wire For Linux
Bypass command list
Key
default_state
default_state
current_state
current_state
watchdog
watchdog
milliseconds (maximum
Value
bypass|disconnect
bypass|disconnect|
normal
enable|disable|lock|
ping
timeout in
is 60000)
Return
bypass|disconnect
bypass|disconnect|
normal
enabled|disabled
timeout in
milliseconds
Page 223