Pride QUANTUM SERIES Owner's Manual page 26

V . C O M F O R T
Armrest Width Adjustment
You can change each armrest's width independently of the other.
NOTE: Changing the armrest width may increase the
overall width of your power chair.
To change the armrest width:
1. Locate the armrest knob on each side of the armrest
receiver bracket. See figure 18.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the knobs.
Armrest Angle Adjustment
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to
the floor. See figure 18.
2. Loosen the locking nut.
3. Turn the adjusting screw to raise or lower the front of
the armrest.
4. Tighten the locking nut to lock the adjusting screw into place.
Controller Position
You can position the controller for either left-hand or right-
hand use.
WARNING! Do not place the controller cable
so that it can be pinched in the seat frame or
the power base frame.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the floor.
2. Loosen the setscrew on the controller bracket. See fig-
ure 16.
3. Slide the controller into or out of the armrest to the de-
sired position.
4. Tighten the setscrew to secure the controller.
To change the controller position:
1. Turn off the power to the controller.
2. Loosen the rear shroud fasteners and remove the rear shroud. See figure 6.
3. Unplug the controller connector(s) from the power base.
4. Remove any wire ties securing the controller cable to the armrest. See figure 6.
5. Loosen the mounting screws in the mounting block. See figure 20.
6. Move the controller mounting block and controller to the other armrest and tighten the mounting screws.
NOTE: If your power chair is equipped with a Synergy or TRU-Balance Seating System, refer to the controller
adjustment information contained in separate manuals.
26
A D J U S T M E N T S
Figure 19. Underside of Armrest
Figure 20. Mounting Block Controller Installation
www.quantumrehab.com
SETSCREW
MOUNTING
MOUNTING
SCREWS
BLOCK
Quantum 610