Table of Contents
Advertisement
4. Use the screwdriver to tighten the two screws 1 until the computer cover is
Installing a computer stand
To install a computer stand, do the following:
1. Turn off the computer.
2. Disconnect all cables, power cords, and external options from your computer.
3. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your
4. Position the computer stand over the back of the computer and insert the two
5. Lower the rear of the computer stand down until it is lying flat and parallel to
126
Hardware Maintenance Manual
fully installed on the computer.
See "Rear connectors" on page 78.
computer and gently lay it down so that the screen is against the surface and
the bottom is facing you.
tabs at the front of the computer stand into the two holes in the cover at an
angle.
the computer cover.
Advertisement
Table of Contents
