18. Remove the integrated webcam and integrated webcam cable from the
Installing an integrated webcam
To install an integrated webcam, do the following:
112
Hardware Maintenance Manual
computer.
1. Position the new integrated webcam tabs into the integrated webcam slots
and then press the integrated webcam 1 downward until the integrated
webcam-locking tabs 2 snap into position.
2. Connect the integrated webcam cable to the system board and route the
excess integrated webcam cable along the side of the main bracket. See
"System board connectors" on page 81.
3. Reinstall all the 11 screws that secure the main bracket to the front bezel.
4. Reinstall the system board. See "Installing a system board" on page 105.
5. Reinstall the microprocessor and heat sink assembly. "Installing the
microprocessor and heat sink assembly" on page 103.
6. Remove the microprocessor fan assembly. See "Installing a microprocessor fan
assembly" on page 99.
7. Reinstall the memory modules. See "Installing a memory module" on page 95.
8. Reinstall the power supply assembly. See "Installing a power supply
assembly" on page 120.