Table of Contents
Advertisement
Diagnostic Error Code
030-198-XXX
SCSI interface test aborted
030-199-XXX
SCSI interface test failed, cause unknown
035-000-XXX
RAID interface Test Passed
035-0XX-XXX
RAID interface Failure
035-195-XXX
RAID interface Test aborted by user
035-196-XXX
RAID interface test halt, error threshold
exceeded
035-197-XXX
RAID interface test warning
035-198-XXX
RAID interface test aborted
035-199-XXX
RAID interface test failed, cause unknown
071-000-XXX
Audio port Interface Test Passed
FRU/Action
1. If a component is called out, make sure
it is connected and/or enabled. See
Chapter 6, "Using the Setup Utility," on
page 45
2. Flash the system and re-test. See "Flash
update procedures" on page 157
3. Go to "Undetermined problems" on page
75
1. Go to "Undetermined problems" on page
75
2. Flash the system and re-test. See "Flash
update procedures" on page 157
3. Replace component under function test
No action
1. RAID signal cable
2. RAID device
3. RAID adapter card, if installed
4. System board
Information only
Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called
out is connected and/or enabled. See
Chapter 6, "Using the Setup Utility," on
page 45
2. Re-run test
3. Replace the component that is called out
in warning statement
4. Replace the component under test
1. If a component is called out, make sure
it is connected and/or enabled. See
Chapter 6, "Using the Setup Utility," on
page 45
2. Flash the system and re-test. See "Flash
update procedures" on page 157
3. Go to "Undetermined problems" on page
75
1. See "Undetermined problems" on page
75
2. Flash the system and re-test. See "Flash
update procedures" on page 157
3. Replace component under function test
No action
Chapter 7. Symptom-to-FRU Index
63
Advertisement
Table of Contents
