Installing A Computer Stand - Lenovo ThinkCentre A70z Hardware Maintenance Manual

3. Lower and press one end of the computer cover into place first and then close the other end until
the computer cover fits snugly on the computer.
4. Use the screwdriver to tighten the two screws
computer.

Installing a computer stand

To install a computer stand, do the following:
1. Turn off the computer.
2. Disconnect all cables, power cords, and external options from your computer. See "Rear connectors"
on page 65.
3. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the bottom is facing you.
4. Position the computer stand over the back of the computer and insert the two tabs at the front of the
computer stand into the two holes in the cover at an angle.
5. Lower the rear of the computer stand down until it is lying flat and parallel to the computer cover.
1 until the computer cover is fully installed on the
.
Chapter 8 Replacing FRUs
109