Irda And Com (Serial) Connectors - LanParty Blood-Iron P45 Elite Series User Manual

2
Hardware Installation

IrDA and COM (Serial) Connectors

IrDA
Connect the cable connector from your IrDA module to the IrDA connector.
Note:
The sequence of the pin functions on some IrDA cable may be reversed
from the pin function defined on the system board. Make sure to connect
the cable to the IrDA connector according to their pin functions.
You may need to install the proper drivers in your operating system to use the
IrDA function. Refer to your operating system's manual or documentation for
more information.
COM (Serial)
The COM (Serial) connector is used to connect modems, serial printers, remote
display terminals, or other serial devices. Your COM port may come mounted on
a card-edge bracket. Install the card-edge bracket to an available slot at the rear
of the system chassis then connect the serial port cable to this connector. The
colored edge of the cable should align with pin 1 of this connector.
36
IRRX
N. C.
Ground
VCC IRTX
IrDA 1 5
2
COM
1 9
C217