Control Own Camera - Cisco MX200 User Manual

47 Camera

Control Own Camera

Using your camera position presets:
In a call (shown
here) or outside
a call, tap
Camera, as outlined.
Adjusting your camera's pan, tilt and zoom:
In a call (shown
here) or outside
a call, tap
Camera, as outlined.
Pan
Tilt
Zoom
Pos. 1
Select the preset
to use, as outlined.
Tap Selfview (a) and
then adjust Pan, Tilt and
Zoom (b), as outlined.
Pos. 1
Tap anywhere outside
the menu to exit.
Tap anywhere outside the
menu to exit.
About Camera Control
Existing camera presets can be used
right away during a call.
Your video system may have more
than one camera, for example one
camera showing the participants,
while another shows the whiteboard.
If you need to add new or modify
existing camera presets, this is done
in the same way as you do outside
a call—turn to "Edit Existing Camera
Position Preset" on page 46 for
details.
As an alternative to adding or editing
presets, a simple adjustment of your
camera's pan tilt and zoom should
also be considered.
D1458221 User Guide Cisco TelePresence
Profile Series, Codec C-series, Quick Set C20
SX20 Quick Set, MX200, MX300
Produced: December 2014 for TC7.3
All contents © 2010–2014
Cisco Systems, Inc. All rights reserved.