Gas & Electrical - BONAIRE WFBL26 Installation Instructions Manual

D W F
ELUXE ALL URNACE
Gas & Electrical
Gas & Electr ical
G
AS
Important note
When connecting the gas supply inlet
pipe to the gas
connection nipple on the valve with a
spanner while tightening the inlet pipe
compression nut. This ensures the
nipple is not over tightened.
Technologies is not responsible for a
cracked gas valve casting due to over
tightening during the installation. The
replacement valve
covered by warranty.
1. Natural Gas: The connection on heater
is a ½" BSP compression fitting. Flare
the copper connection tube using a flare
nut to connect to the unit.
2. Use gas copper pipe to AS 1432 Type B
or other approved gas piping.
3. Have a licensed gas fitter install the gas
supply pipe. The gas supply can be
plumbed from the ceiling or from a low
level either from the floor or through an
outside wall
installation.
Note: Ensure the gas line has been
purged of any inline fragments before
connecting to the gas valve. This is
especially important where a new gas
service has been installed.
Warranty will be voided if the gas
valve is damaged
fragments.
4. Pipe entry
approximately 150mm above the datum
line. Leave around 250mm (Inbuilt) or
350mm (Console) of tail to make the
connection to the gas valve.
5. A gas cock is not required for domestic
application. However for commercial
applications the installer must supply and
fit an AGA approved ½" gas cock to suit
the gas specified.
valve, hold
Climate
is therefore
depending on
with inline
to the product
E
LECTRICAL
1. Have a licensed Electrician install a 10
Amp
outlet).
the
Note:
outlet is correct otherwise the flame
can't be sustained and the heater
won't operate.
2. The GPO should be installed within
750mm of the left side or 350mm of the
right side of the heater.
not
3. Plug the pre-wired service lead into the
GPO once the installation is complete.
Note:
to reach the GPO, as this is unsafe.
Where required, have an Electrician
relocate the GPO.
the
is
Page 8
3 pin GPO (general-purpose
Ensure the polarity of the
Do not use an extension cord