Table of Contents
Advertisement
D
W
F
ELUXE
ALL
URNACE
Unit Installation
I
I
NSTALLING THE
NBUILT
1.
Install the heater assembly:
1.1. Fit flue insulation over flue spigot
before inserting into the header plate
1.2. Insert the flue spigot of the heater
assembly into the header plate flue
access / twin skin inner flue.
1.3. Place the bottom of the unit onto the
base plate locating it behind the
retaining angle.
2.
Make the gas connection using a flare and
flare nut connection see fig.1.
3.
Connect the thermostat loom to the circuit
board
4.
Connect the cabinet earth lead
5.
Commission
the
commissioning instructions.
6.
Place front cabinet onto unit:-
6.1. Fit the cabinet over the unit with the top
above the locating teeth on the top of
the unit and slide the cabinet down into
the bottom plastic housing. (You will
need to give the cabinet a slight bow for
it to fit the moulding)
6.2. Fit the bottom of the metal cabinet into
the bottom plastic housing ensuring the
top is located over the metal catches.
6.3. Ensure the cabinet is fitting flush
against the wall All the cabinet to slide
down into place with a flush fit against
the wall
6.4. Secure the cabinet by fixing the top of
the cabinet with the 2 screws supplied.
See fig.3
H
EATER
product
as
per
Fig. 3
the
Page 14
Fig. 1
Hide quick links:
Advertisement
Table of Contents
