Introduction; Conditions; Important Notice To Agents Installers And Purchasers; Incorrect Commissioning - BONAIRE WFBL26 Installation Instructions Manual

D W F
ELUXE ALL URNACE

Introduction

Introduction
C
ONDITIONS
Installation of the Wall Furnace must be
carried out by an authorised person in
accordance with:-
• The manufacturer's instruction.
•
Building regulations
•
Electrical supply authority regulations
•
Australian Standard
Installations AS5601 (AG601).
I
MPORTANT NOTICE TO AGENTS
INSTALLERS AND PURCHASERS
Climate Technologies
appliances of World-Class standard. It's
important that you're aware that problems
can occur if these appliances are not
properly installed. There are standards
covering installation
Standards Australia AS5601 (AG601).
The guidelines for installation in this
document are in accordance with those
standards. If an appropriately qualified
person is not
equipment or if it's not installed according
to the guidelines,
Technologies will not accept responsibility
for any problems that occur as a result.
Relevant certificates of compliance for the
installation must be issued. Service may
be refused or warranty may be void and
your household
affected if the installation does not meet
state relevant compliance.
I
NCORRECT COMMISSIONING
If a Warranty Service Call is required
because the system has been incorrectly
installed or commissioned the cost of the
service call will be charged to the
customer or the
installation.
for Gas
,
manufactures
set down
used to install the
then Climate
insurance may
installer for
S
R
The manufacturer and its agents reserve
the right to refuse service unless the
safety and accessibility to the unit can be
guaranteed.
For Safety Purposes It Is Mandatory
For a Flue To Be Fitted To All Pyrox
Wall Furnace Installations Taking Flue
Gases External To Atmosphere.
This product exceeds 22Kg in weight.
Use handling equipment or safe lifting
practice to maneuver.
P
LEASE READ THESE SAFETY
PRECAUTIONS
by
•
Do not connect your heating appliance to
any power point that hasn't been checked
by a qualified electrician to ensure correct
earthing and polarity (This should be
arranged by your installer).
•
Do not use any type of gas other than that
specified for the heating appliance. Each
Wall Furnace is factory set to operate on
a particular type of gas.
•
Do not place any articles in front of or on
the sides of the Wall Furnace.
•
Do not place any articles on or against
your heating appliance.
be
•
Do not use or store flammable materials
near this appliance.
•
Do not spray aerosols in the vicinity of this
appliance while it is in operation.
Please read the correct sections of this
guide and make sure you understand
them before commencing the installation.
the
Page 3
& A
AFETY CCESSIBILITY
ESPONSIBILITY