Advertisement
SD7K
Assembly instructions
As a by-product of the manufacturing process, occasionally some metal shavings or burs will unavoidably remain.
To avoid injury, please watch your fingers when adjusting clamps, or when working around pipe-ends and screw-ends.
Inside this package
Before assembly, please make sure that all the items listed below are present.
Cymbal 3pcs
3 Cymbal Pads
Drum Pads
Snare Pad
2 Metal Rods
Accessories
Cymbal Holder (Short)
2 Drumsticks
AC Adaptor
Side Arm (L1)
Cymbal Holder Clamp
Pillar (L)
Lock
Lock
Clamp
Leg (L)
Clamp
Cross Pipe
Rubber Feet
Drum Pads
Tom Pad
2 Tom Pads
2 Metal Rods
Metal Rod
Hexagon Key (5mm)
Instruction Manual
Side Arm (L2)
Holder Clamp
Pillar (R)
Connector
Leg (R)
Connector
Connector
CAUTION!
9 Connecting Cables
Drum Key
Assembly Instructions
2 Cymbal Holders (Long)
Holder Clamp
Lock
Connector
Clamp
Cross Pipe
Clamp
Rubber Feet
SD7K
digital drum assembly instructions
Kick Pad
Kick Pad
Hi-Hat Pedal
Hi-Hat
Control Pedal
Drum Module
Drum Module
Side Arm (R)
Cymbal Holder Clamp
Holder Clamp
Center Pipe (2)
Center Pipe (1)
Holder Clamp
Advertisement
Table of Contents
Related Manuals for Simmons SD7K
Summary of Contents for Simmons SD7K
-
Page 1: Assembly Instructions
SD7K Assembly instructions CAUTION! As a by-product of the manufacturing process, occasionally some metal shavings or burs will unavoidably remain. To avoid injury, please watch your fingers when adjusting clamps, or when working around pipe-ends and screw-ends. Inside this package Before assembly, please make sure that all the items listed below are present. - Page 2 Attach the Side Arm (L2) to the clamp on the Pillar (L). Attach the Side Arm (R) to the clamp on the Pillar (R) Tighten the screws on the clamp. Tighten the screws on the clamp. SD7K digital drum assembly instructions...
- Page 3 Attach the Cymbal pads to the Cymbal Holders. Re-attach the Felt Washer and Wing Nut, then tighten the Wing Nut of each Cymbal Holder. Repeat for other cymbals. Wing Nut Felt Washer Wing Nut Felt Washer SD7K digital drum assembly instructions...
- Page 4 Metal Rod 5. congratulations You’ve successfully assembled your new Simmons SD7K electronic drum kit. You can now attach your own bass drum pedal to the kick pad. Also, be sure to attach the clearly marked cables from the pads to the correct inputs on the drum module.
Need help?
Do you have a question about the SD7K and is the answer not in the manual?
Questions and answers