Installation And First Use; Switching The Machine On And Off; Setting The Speed - Parkside PTBM 350-13 Operating And Safety Instructions Manual

INSTALLATION AND FIRST USE

Check that the supply type, voltage and fuses comply with those specified for the machine.
First clean any anti-rust coating carefully from the parts. Then oil the column.

SWITCHING THE MACHINE ON AND OFF

Insert the plug into the mains socket and switch on the machine using the "I" button at the
on/off switch . To switch off use the "0" button.
CHECKING AND TENSIONING THE V-BELT
Open the drive/belt cover
should be able to be moved approximately 1 cm in the middle between the two drive wheels.
Loosen the adjustment screw
adjustment screw .

SETTING THE SPEED

The bench drill has 5 different speeds. The speed is set by simply repositioning the V-belt. To do
this open the drive/belt cover , loosen the adjustment screw
relevant pair of drive wheels.
Note: The top pair give the highest speed; the bottom pair the lowest ( =2600,
= 1250, = 900,
Then tension the V-belt as described in the section on "Tensioning the V-belt".
Note: Inside the drive/belt cover
contact (see ) on the drive/belt casing base when the drive cover is closed. The motor can only
be restarted if the drive/belt cover
SETTING THE DRILLING TABLE
The drilling table
Set the table so that there is an adequate distance between the workpiece top surface
and the drill bit point.
The table can be swung to the side, e.g. when you wish to work on a tall workpiece that can be
attached directly to the base plate.
DEPTH STOP / DRILLING TO AN EXACT DEPTH
The depth stop with its scale
First of all press lightly down on to the top of the workpiece surface using the handle
the drilling depth using the adjustment nut
Note: Make sure that you take into account the length of the drill bit point (normally approx.
5 mm) when determining the appropriate setting for the cylindrical part of a drilled hole.
INCLINED DRILLING
The drilling table
with inclined ends. Release the hexagonal socket screws on the drilling table swivel joint.
Place the table at the required slope and retighten the hexagonal socket screws.
and check the V-belt tension. If it is correctly adjusted the V-belt
and press the motor unit
= 600, see figure on page 3).
there is a contact which must come together with an opposing
is properly closed.
can be adjusted by loosening the table clamp screw .
allows you to drill to an exact depth.
can be rotated to drill angle holes or to accommodate workpieces
backwards before retightening the
and place the V-belt on the
on the scale.
6
= 1750,
and set