Dish Network ViP211k User Manual page 59

Chapter 9
Controlling Other Components
Instructions
10
If the code doesn't work, redo steps 3
through 9 with another device code
from the tables.
11
If you can't find a code that works try,
Setting Up Using Device Codes Scan
that follows.
Setting Up Using Device Codes Scan
If the code for your device is not listed in the tables starting on page 98, use this procedure
to scan the remote control's memory for the device code. In the instructions below, the
column on the left contains the instructions and the column on the right provides additional
information.
Instructions
1
Turn the device on.
2
Press and hold the mode button until
all the other mode buttons light up, and
then let go of the button. The mode
button flashes.
3
For AUX mode only. Press 0 for a
second TV, or 1 for a second VCR,
or 2 for a tuner, or amplifier. Then press
the STAR (*) button.
4
If you want to program Limited Mode,
press PAGE UP. If not, skip to step 7.
5
Press POWER.
52
Additional Information
Try every code listed for your brand until one
works for your device.
Additional Information
Use the device's front panel buttons or its
remote control.
For example, hold TV for a TV until all of the
other mode buttons light. When you let go, TV
will flash.
This step is for programming which kind of
device that should be programmed in AUX
mode. If you're not programming in AUX mode,
skip to step 4.
See Limited Mode for more information.
This puts your remote in the scan mode.