Points to notice for Inspection & Adjustment of Flash
When the adjustment item
*Be sure to make the adjustment in a dark place (e.g. photo darkroom, etc) without influence of outside light.
*If there is some reflector (e.g. desk, etc) in front of SB, it may affect the accuracy.
Therefore, be sure to align both the edges of the communication tool (J15405) and stand (desk, etc) as shown below.
Flash meter
Align the edges of the communication tool
(J15405) and the stand (desk, etc).
Standard reflector *
* SB-600 does NOT have "Auto mode", so inspection and adjustment can be
made without the standard reflector. However, if there is something, etc that has
extremely strong reflection in the background, it may affect the accuracy. So it is
recommended to use the standard reflector (J18360/J18069) as background.
3. Quantity of light adjustment
1m
- A19 ・ SB-600 -
is made, be careful of the following:
J15405
FSA03601-R.3629.A
PC