Table of Contents
Advertisement
*If you live in an area that observes DST, DST should be set to ON even if it is
not currently Daylight Saving Time.
You will automatically exit SET MODE if no buttons are pressed for 30 seconds.
Enter SET MODE at any time by pressing the "
" button.
Display Modes
The weather page display has three distinct viewing modes- Manual, Cycle
or Auto-Display. To change between these modes, press the "
" button
located on the front of the display unit.
MANUAL: Manually change the measuremet being displayed using the
"
" or "
" buttons on the front of the display unit.
CYCLE: In cycle display mode, the display will automatically cycle through
all available weather pages. Each page will be displayed for approximately 5
seconds. Note that you may still manually browse through the weather pages
at any time by pressing the "
" or "
" buttons, but the display will begin to
cycle again after 5 seconds of no activity.
AUTO-DISPLAY: In this mode, whichever weather pages have adverse
conditions being reported will display automatically. For example, with auto
display mode selected- if it begins to rain, the "RAINFALL" weather page will
automatically display. If multiple weather pages report adverse conditions
(example; RAINFALL/IN-TEMP), all of the affected weather pages will
automatically display in a cycle until the conditions return to "normal". After
conditions normalize, the weather page that was previously selected will
display again.
BOOKMARK: The bookmark feature allows you to quickly view the weather
page that is most important to you, no matter what display mode you are in.
You may "bookmark" your favorite weather page by pressing AND HOLDING
the "
" button. This will bookmark the currently selected category and allow
you to quickly go to that category at any time. To go to your bookmarked
page, press AND RELEASE the "
" button at any time. Note that the weather
page may change after 5 seconds if you are in CYCLE or AUTO DISPLAY
modes. If you would like to remain on your book marked weather page, press
the "
" button to select manual display mode (
).
7
Advertisement
Table of Contents
