Related Manuals for Royal Cozyfires C603RH
Summary of Contents for Royal Cozyfires C603RH
- Page 1 0104 095 52214 Remote Control Electric Fire Model C603RH Instructions for Use, Installation & Maintenance C603R 010909...
- Page 2 Parts Supplied Description Illustration Electric Fire Decorative Trim, Front and Fret Coal Bed Bag of Coal/Pebbles Spacer Frame (Available as an option, not supplied with all models) (See Fig 2 Page 4) Remote control (With batteries) FLAME 1 kw SAFTEY 2 kw Fittings Supplied Description...
-
Page 3: C603R
Before You Start Please read these instructions carefully before you start installation. Check the pack and make sure you have all of the parts listed on page 2. When you are ready to start, make sure that you have the appropriate tools to hand, plenty of space and a clean dry area for installation. - Page 4 Installation The mains plug must be accessible after installation. Ensure adequate space is maintained for the routing of the supply cord. This appliance has three installation options: - Option 1 Wall or Back Panel Fixing (Screw method) For fitting the appliance into a blocked flue: Offer the firebox into the opening.
- Page 5 Option 3 Wire cable fixing (I) Wire cable fixing should be used with stone or marble panel which could fracture if drilled. (See Fig 3) Fig. 3 Screw eye Retaining Bush Cable fixing holes Max Height Two `screw eyes’ are fixed 330mm to the rear of the opening with wall plugs.
- Page 6 Flat wall fix (FOR REFERENCE ONLY) Flat wall fix is suitable for a mantel with a minimum 2 1 / 4" (57mm) internal rebate; remove the internal rebate from the mantel (Fig .4). Place the back panel into position and offer the appliance up to the opening in the back panel.
- Page 7 Trim location Place each of the four magnets (J) onto the location brackets (Fig.5). Some trim options require extension clips or extra magnets. Remove any protective film from the trim. Fit the trim (B) ensuring positive location against magnets (Fig.6). Magnet Trim location...
- Page 8 Care and Use Fire operation This appliance has both manual and remote operation. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
-
Page 9: C603R
Fig.12 Indicator lamps Enable heat 1 kW & 2 kW heat settings Buttons Remote Control operation (Fig. 13) To prevent accidental heating operation the “Power” button must be pressed and held down whilst activating the “1000W” or “2000W” buttons. For half heat setting (1kW) hold down “Power” and press “1000W” button. For full heat setting (2kW) hold down “Power”... -
Page 10: Figs
Replacing the lamp Disconnect the appliance from the mains! Allow the appliance to cool. Do not use lamps of a higher wattage. Fig.14 Ensure replacement lamp is 230-240 Volts, Small Edison Screw type fitting. (Max. 15W) Anti clockwise Ensure that the lamp holder is held securely when removing or replacing the lamp. -
Page 11: Figs
Technical data Standard Optional Spacer Fitted ( Fig 15 ) ( Fig 16 ) Width at rear ( A ) 370mm 475mm Overall width ( B ) 475mm 475mm Overall height ( C ) 595mm 595mm Height at rear ( D ) 540mm 595mm Depth from fixing plane ( E ) -
Page 12: Spare Parts List
Spare parts list PART DESCRIPTION CROSSLEE PART No. Magnet (manufacturer’s part no. N30H) 42561 Amber long life lamp, 7 Watts (E14) GA607OR Coal pack 0104 078 02981 Remote Handset 0104 092 40291 Spacer Frame 0104 075 33464 Trim options and other spares items are available on request. In the event that you may require service, spares or technical information, please contact us at: - CROSSLEE plc...