Symptom-to-FRU index
Symptom-to-FRU index
The symptom-to-FRU index in this section lists symptoms
and errors and their possible causes. The most likely
cause is listed first, in boldface type.
Note: Do the FRU replacement or other actions in the
sequence shown in the column headed "FRU or
action, in sequence." If replacing a FRU does not
solve the problem, put the original part back in the
computer. Do not replace a nondefective FRU.
This index can also help you determine, during regular
servicing, what FRUs are likely to need to be replaced
next.
A numeric error is displayed for each error detected in
POST or system operation. In the displays, n can be any
number.
If no numeric code is displayed, check the narrative
descriptions of symptoms. If the symptom is not described
there, go to "Intermittent problems" on page 57.
Note
For an IBM device not supported by diagnostic
codes in the ThinkPad notebook computers, see the
manual for that device.
Numeric error codes
Symptom or error
0175
Bad CRC1, stop POST
task—The EEPROM checksum
is not correct.
0177
Bad SVP data, stop POST task.
0182
Bad CRC2. Enter BIOS Setup
and load Setup Defaults.
0185
Bad startup sequence settings.
Enter BIOS Setup and load
setup defaults.
50
ThinkPad G40
FRU or action, in sequence
System board.
System board.
Run IBM BIOS Setup Utility
and Load Setup Defaults.
Run IBM BIOS Setup Utility
and Load Setup Defaults