Thegigrig Pro-14 Quick Start - The GigRig Pro 14 Manual

3. TheGigRig Pro-14 Quick Start

Using TheGigRig couldn't be easier.
First, connect your Pro-14 to your amplifier before applying power.
TheGigRig can supply power to your 9V effects pedals. See (24) above, 9V
out.
Plug the effects you wish to use into the effects loops in the back of the
Pro-14 in the order you wish to use them. The effects send (snd) from
the Pro-14's effects loops plugs into the input of your effect and the
output of your effect plugs into the return (rtn).
Your signal path moves from right to left, from effects loops 1~10.
The order in which you place your effects makes a big difference to your
sound, so experiment and find the sounds you like. (For more info see
F.A.Q's.)
Now plug your amp(s), into the output(s) on the left-hand side of
TheGigRig.
Let's take a look at one of the 14 pre-sets:
To programme, simply turn on the effects loops and control functions you
want for this pre-set. That's It!
All rights reserved. Design rights claimed. Moral rights asserted. © May 2008
©
The 10 effects loops' switches
operate the effects loops in
TheGigRig.
The 6 Control switches operate
the control functions.
These are:
1- Post effect loop volume; you
can set a different volume for
each pre-set
2- Pre-effect loop buffer
3- Remote switch 1 (normally
closed)
4- Remote switch 2 (normally
open) use these switches to
control amp Functions such as
channel selection and reverb.
5- Out 1 mute
6- Out 2 mute
The GigRig ltd Jan 2009
Page 4