Mixing Tremolo (5.4Hz); Bank On; Bypass Foot Switch; Foot Switch Aux - The GigRig Pro 14 Manual

The GigRig ltd Jan 2009
©
Foot Switch 12: Mixing Tremolo (5.4Hz)
Hold down for 3 seconds to select the same Tremolo effect as with
switch 11. But, with a faster tremolo.
Foot Switch 13: bank on
Hold down for 3 seconds to switch all patches/presets on the top bank to
on.
Tip. This is a useful test mode. When selected check to see that only the
green output LEDs that have effects plugged in are on. Do the same using
switch 6 for the bottom bank; you can do both together.
Foot Switch 14: Bank off
Hold down for 3 seconds to clear the top bank.
Tip, this feature can be very useful, as it will not clear mode 2 patches
set on the bottom bank unlike the bypass switch. If both banks are set to
mode 1 holding down this switch will select Standby mode. (All
patches/presets and bypass light off with the guitar connected to the
amp)

Bypass Foot Switch

Hold down for 3 seconds or above to enable the pop gate feature on the
bottom bank.
TheGigRig will now gate out pops and clicks from your effects pedal when
they are selected.
To disable the pop gate feature, on this Rail, hold down foot switch 1 for
3 seconds or more.
Note. you can see the output lights flash when you press a foot switch if
Pop-Gate is on.

Foot Switch Aux.

Hold down for 3 seconds or above to enable the pop gate feature on the
top bank.
The GigRig will now mute out pops and clicks from old high gain your
effects pedal when they are selected and de selected.
To re enable the pop gate feature, on this bank, hold down foot switch 8
for 3 seconds.
Note. you can see the output lights flash when you press a foot switch if
Pop-Gate is on.
Tips and Tricks:
All rights reserved. Design rights claimed. Moral rights asserted. © May 2008 Page 15