Special Functions; Light Show; Software Version Bottom Bank; Very Slow Clean Tremolo Effect - The GigRig Pro 14 Manual

The GigRig ltd Jan 2009
©

9. Special Functions

A range of special functions for the adventurous guitarist.
Set the mode switch to 1 and hold down a foot switch for over 3 seconds
to access the following special functions:
Foot Switch 1: Light show (and self-test)
Hold down for 3 seconds and the bottom bank will run through the wizzy
light show (and self test). The output will be muted until the show is
completed.
The pop gate feature will be disabled on the bottom bank at the end of
the show. Try holding down switches 1 and 8 together for 3 seconds.
Foot Switch 2: Software version bottom bank
Hold down for 3 seconds to read the software version number. The
version number will flash on and off.
Foot Switch 3: Very Slow clean Tremolo effect (2.3Hz)
Switch control switch 1 (post vol) to the 'on' position to access this
effect. Hold down foot switch 3 for three seconds or more to enable the
tremolo. Now use the post volume control for the tremolo intensity
(depth).
Tip; switch in the pre buffer switch (control switch 2) to reduce to the
desired volume level using the pre volume control.
You can now combine this tremolo effect with your effects loops on this
Pre-set.
You can also mix in other effects by setting the upper bank to mode 2.
Try it!
Foot Switch 4: medium speed clean Tremolo effect (3.2Hz)
This works the same as above, but with a faster tremolo sound.
Foot Switch 5: Fast speed clean Tremolo effect (5.4Hz)
This works the same as above, but with a still faster tremolo sound.
Foot Switch 6: Bank on
All rights reserved. Design rights claimed. Moral rights asserted. © May 2008 Page 13