Samsung DCS Compact User Manual page 24

DATA SECURITY
Single line extensions used with modems and facsimile machines can be programmed
so that they will not receive any system-generated tones that would disrupt data trans-
missions. In addition, these devices will receive DCS COMPACT C.O. ringing pattern
instead of intercom ring pattern. Devices connected to a 2 SLI card or a 2 x 4 SLI card
will receive a disconnect signal upon termination.
DATABASE PRINTOUT
A copy of the customer database can be obtained using CPCMMC. This information can
be directed to an image file for later printing or to the PC screen and may be done either
on-site or remotely. A complete database or specific data blocks may be obtained.
DIAL BY NAME
SYSTEM SPEED DIAL LIST
Each system speed dial number can have an associated directory name. A speed dial
number can be selected by scrolling alphabetically through the directory name list.
This on-line "directory" allows the user to look up and dial numbers in seconds.
PERSONAL SPEED DIAL LIST
Each personal speed dial number can have an associated directory name. A speed
dial number can be selected by scrolling alphabetically through the directory name list.
This on-line "directory" allows the user to look up and dial numbers in seconds.
STATION DIRECTORY LIST
Each station can have an associated directory name. A station can be selected by
scrolling alphabetically through the directory name list. This on-line "directory" allows
the user to look up and dial other users in seconds.
DIRECT IN LINES
Outside lines may be programmed to bypass the operator(s) and ring directly at any
station or group of stations.
DIRECT INWARD SYSTEM ACCESS (DISA)
Users can call in on specific DISA lines at any time, input a security code and receive
system dial tone. Users can now place internal calls or if permitted, calls using C.O.
lines. The caller must have a tone dial phone and know his/her DISA security code.
DISA lines can be used as both-way lines or incoming only. The C.O. lines used for
DISA must have disconnect supervision.
DIRECT TRUNK SELECTION
Each station can be allowed or restricted access to a trunk or trunk group by access code
when LCR is activated. When restricted, the user must use a trunk key or route key.
4.1.8
CONTENTS