Cleaning The Motor Block; After Cleaning; Storage - Silvercrest KH 528 Operating Instructions Manual

Should this not dislodge the soiling, you can separate
the lower plastic part of the mixer jug
r
ters ) from the the glass part:
➩
Remove the mixer jug
u
.
➩
Turn the plastic element
ment e anti-clockwise, such that it allows itself to
be released from the glass element
Attention!
Take care with the cutters
Risk of injury!
➩
Clean both parts thoroughly in a mild soapy
solution or in a dishwasher.
➩
Replace the plastic part
back onto the glass part
ling ring is correctly fitted.
e (with the cut-
e
from the motor block
of the mixer attach-
.
. They are very sharp.
of the mixer jug e
. Ensure that the sea-

Cleaning the motor block

➩
Use a dry cloth or, at the most, a lightly moistened
one for cleaning the plastic surfaces.
➩
At every cleaning check that the contact switch
in the receptor for the mixer jug
ked by soiling residues. If you cannot dislodge
any blockages with the corner of a piece of pa-
per, make contact with Customer Services. Un-
der no circumstances should you use a hard ob-
ject, this could damage the contact switch.
➩
Remove any possible residues on the underside
of the motor block
stiff bristled brush. Ensure that nothing can enter
through the ventilation opening of the appliance.

After cleaning

Allow all parts to dry well before re-assembling and
re-using the liquidiser.

Storage

➩
If you do not intend to use the liquidiser for an
extended period, clean it thoroughly (see chapter
"Cleaning").
➩
Wrap the power cable
i
rage on the base of the motor block
➩
Store the liquidiser at a cool and dry location.
- 6 -
e
is not blok-
u
only with a dry cloth or a
y
around the cable sto-
u
.