4. Release the lock of the board holder and open the AE-
31 board in the arrow direction.
5. Check by eye that the unit is in the state to be able to
wind manually the tape.
6. Pull the ME wire for a few times with short steps to
take up the tape inside the cassette.
m
. Be careful for the tape not to catch in parts such as a
flange of a tape guide.
. Don't take the ME wire off the wire holder.
. The ME wire links with the T real table.
The T real table rotates about 1/24 turns clockwise
(take-up direction) by pulling the ME wire about 6 mm.
7. Rotate the M gear of the threading motor block in the
arrow direction on the EJECT label by about a half
turn to slack off the tape.
8. Pull the ME wire for a few times with short steps in
the arrow direction on the EJECT label to take up the
tape inside the cassette.
M gear
EJECT
label
Gear box assembly
1-24
AE-31 board
Board holder
EJECT
label
ME wire
Wire holder
9. To wind up the tape into the cassette, repeat steps 7
and 8.
10. Check that the ME wire is slacken.
n
On completely winding up the tape into the cassette,
the M gear will be tighten.
(Unthreading end state)
11. Open the lower control panel.
12. Turn the eject knob in the arrow direction on the label
until the cassette is completely ejected.
Label
Eject knob
SRW-5000