Sony SRW-5000 Installation Manual page 14

. Mounting in rack
c
Be sure to carry the unit by the two persons or more.
17. Set each ball retainer to the position as shown in the
figure in the direction of the arrow.
Front side
Ball retainer
18. Pull equal length of each rail on both sides out.
19. Lift the unit holding the gripes on both sides, slowly
insert the inner rails into the intermediate rails.
20. While pressing each stopper of inner rails on both
sides, slowly push the unit into the rack.
c
Be careful not to catch your finger or hand in rack
mount rail.
Stopper
Inner rail
1-8
Intermediate rail
Slide
Intermediate rail
Stopper
21. Slide the unit in and out from the rack about three
times and check that the slide rails move smoothly.
If they are not smoothly, demount the unit and go back
to "Attaching the outer rails" (step 12).
c
When demounting the unit, carry it by the two persons
or more.
n
This unit does not have the feet at this operating.
Put down the unit on the floor or other, being careful
not to damage the unit.
22. Push the unit in the depths of the rack. The unit is
fixed to the rack by the lock mechanism.
Attempt to pull the rack angles and confirm that the
unit cannot be pulled out of the rack.
23. Secure the unit to the rack with the four screws (RK5
x 14) and four ornamental washers.
Tightening torque: 120 x 10
Ornamental
washer
RK5 x 14
RK5 x 14
_2
N.m {12.2 kgf.cm}
Ornamental
washer
SRW-5000